Silquest A-1100®

Catalog Number
PLAS-CA-002N
Number of Components
1
Unit
50 mg
Price(USD)
$50.00
 
  

Additional Information

Storage Condition
Ambient (>5 °C)
Safety Data Sheet
 
 
AnalyteCAS NumberTarget Concentration
Silquest A-1100®919-30-2N/A

Silquest A-1100®

Double click on above image to view full picture

Zoom Out
Zoom In
Molecular Formula
C9H23NO3Si
Molecular of Weight
221.37
Melting Point (°C)
<-70 °C
Boiling Point (°C)
220 °C
Flash Point (°C)
205 °F / 96 °C (pmcc)
 
 
Symbol
Signal word
Danger
Hazard statements
May cause kidney and liver damage. (Specific target organ toxicity, single exposure, category 2)
May cause skin sensitization. (Sensitization, skin, category 1)
May cause dizziness, nausea, incoordination, or anesthesia. (Specific target organ toxicity, single exposure; Narcotic effects, category 3)
Aspiration hazard if swallowed - may be fatal if swallowed and enters airways. (Aspiration hazard, category 1)
Causes eye burns. (Category 1)
Harmful if inhaled. (Acute toxicity, inhalation, category 4)
Harmful if absorbed through skin. (Acute toxicity, dermal, category 4)
May be fatal if swallowed. (Acute toxicity, oral, category 2)
Causes skin burns. (Skin corrosion/irritation, category 1)
Fatal if swallowed. (Acute toxicity, oral, category 1)
Fatal if inhaled. (Acute toxicity, inhalation, category 1)
Precautionary statements
Eye contact: Immediately flush with plenty of water. After initial flushing, remove and contact lenses and continue flushing for at least 15 minutes. Assure adequate flushing by separating the eyelids with fingers.
Skin contact: Immediately wash skin with soap and plenty of water. Remove contaminated clothing. Get medical attention if symptoms occur. Wash clothing before reuse.
Ingestion: Do NOT induce vomiting. Call a physician or poison control center immediately. Never give anything by mouth to an unconscious person.
Store in a tightly closed container.
Do not get in eyes, on skin or clothing.
This product should only by used by persons trained in the safe handling of hazardous chemicals.
Wash thoroughly after handling. Do not take internally. Eye wash and safety equipment should be readily available.
Respiratory Protection: If workplace exposure limit(s) of product or any component is exceeded (see TLV/PEL), or a risk assessment shows air-purifying respirators are appropriate, use of a NIOSH/MSHA approved air supplied respirator is advised. Use a full-face respirator with multi-purpose combination (US) or type ABEK (EN14387) respirator cartridges in absence of proper environmental control. Always use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU). Engineering and/or administrative controls should be implemented to reduce exposure.
 
 
UN Number
UN1760
Class
8
Packing Group
II