Silquest A-1100®

Catalog Number
1000 µg/mL in Hexane
Number of Components
1 mL

Additional Information

1000 µg/mL
Storage Condition
Ambient (>5 °C)
Safety Data Sheet
AnalyteCAS NumberTarget Concentration
Silquest A-1100®919-30-21000 µg/mL

Silquest A-1100®

Double click on above image to view full picture

Zoom Out
Zoom In
Molecular Formula
Molecular of Weight
Melting Point (°C)
-95 °C (-139 °F)
Boiling Point (°C)
68 - 70 °C
Flash Point (°C)
-14.8 °F (-26 °C) (cc)
Signal word
Hazard statements
May cause dizziness, nausea, incoordination, or anesthesia. (Specific target organ toxicity, single exposure; Narcotic effects, category 3)
Suspect reproductive hazard. (Reproductive toxicity, category 2)
Aspiration hazard if swallowed - may be fatal if swallowed and enters airways. (Aspiration hazard, category 1)
Highly Flammable (Flammable liquids, category 2)
Harmful if swallowed. (Acute toxicity, oral, category 4)
Harmful if inhaled. (Acute toxicity, inhalation, category 4)
Irritating to skin. (Skin corrosion/irritation, category 2)
May be irritating to mucous membrane and upper respiratory system. (Specific target organ toxicity, single exposure; Respiratory tract irritation, category 3)
Precautionary statements
Eye contact: Immediately flush with plenty of water. After initial flushing, remove and contact lenses and continue flushing for at least 15 minutes. Assure adequate flushing by separating the eyelids with fingers.
Skin contact: Wash thoroughly with soap and water. Get medical attention if irritation develops or persists.
Ingestion: Do NOT induce vomiting. Call a physician or poison control center immediately. Never give anything by mouth to an unconscious person.
Store in a tightly closed container.
Do not get in eyes, on skin or clothing.
This product should only by used by persons trained in the safe handling of hazardous chemicals.
Wash thoroughly after handling. Do not take internally. Eye wash and safety equipment should be readily available.
Respiratory Protection: If workplace exposure limit(s) of product or any component is exceeded (see TLV/PEL), or a risk assessment shows air-purifying respirators are appropriate, use of a NIOSH/MSHA approved air supplied respirator is advised. Use a full-face respirator with multi-purpose combination (US) or type ABEK (EN14387) respirator cartridges in absence of proper environmental control. Always use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU). Engineering and/or administrative controls should be implemented to reduce exposure.
Protective gloves must be worn to prevent skin contact.
UN Number
Packing Group