Silquest® A-1102

Catalog NumberCat. #
PLAS-CA-003N
Number of ComponentsComps
1
UnitUnit
50 mg
Price(USD)Price
$50.00
 
  

Additional Information

Storage ConditionStorage
Ambient (>5 °C)
Safety Data SheetSDS
 
 
AnalyteCAS NumberTarget Concentration
Silquest® A-1102919-30-2-TN/A
Molecular Formula Mol. Formula
C9H23NO3Si
Molecular Weight Mol. Weight
221.37
Melting Point Melting Point
<-70 °C
Boiling Point Boiling Point
220 °C
Flash Point Flash Point
205 °F / 96 °C (pmcc)
Symbol
HAZ00004 HAZ00005 HAZ00006
Signal word
Danger
Hazard statements
May cause kidney and liver damage. (Specific target organ toxicity, single exposure, category 2)
May cause skin sensitization. (Sensitization, skin, category 1)
May cause dizziness, nausea, incoordination, or anesthesia. (Specific target organ toxicity, single exposure; Narcotic effects, category 3)
May cause allergic skin reaction. (Sensitization, skin, category 1)
Aspiration hazard if swallowed - may be fatal if swallowed and enters airways. (Aspiration hazard, category 1)
Causes eye burns. (Category 1)
Harmful if swallowed. (Acute toxicity, oral, category 4)
Causes skin burns. (Skin corrosion/irritation, category 1)
Precautionary statements

Eye contact: Immediately flush with plenty of water. After initial flushing, remove and contact lenses and continue flushing for at least 15 minutes. Assure adequate flushing by separating the eyelids with fingers. (P338)
Skin contact: Immediately wash skin with soap and plenty of water. Remove contaminated clothing. Get medical attention if symptoms occur. Wash clothing before reuse. (P360)
Ingestion: Do NOT induce vomiting. Call a physician or poison control center immediately. Never give anything by mouth to an unconscious person. (P331)
Store in a tightly closed container. (P404)
Do not get in eyes, on skin or clothing. (P262)
This product should only by used by persons trained in the safe handling of hazardous chemicals. (P202)
Wash thoroughly after handling. Do not take internally. Eye wash and safety equipment should be readily available. (P264)
Respiratory Protection: If workplace exposure limit(s) of product or any component is exceeded (see TLV/PEL), or a risk assessment shows air-purifying respirators are appropriate, use of a NIOSH/MSHA approved air supplied respirator is advised. Use a full-face respirator with multi-purpose combination (US) or type ABEK (EN14387) respirator cartridges in absence of proper environmental control. Always use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU). Engineering and/or administrative controls should be implemented to reduce exposure.

UN Number UN #
UN1760
Shipping Class Shp Class
8
Packing Group Packing
II