Aniline Point Standard (77 ºC)

Catalog NumberCat. #
CRM DesignationCRM Designation
Reference Material
Number of ComponentsComps
20 mL

Additional Information

CRM Designation
Reference Material
The product is sold as part of a set or kit, and is not available for individual sale.
Storage ConditionStorage
Ambient (>5 °C)
Safety Data SheetSDS
AnalyteCAS NumberTarget Concentration

Aniline Point Standard (77 ºC)

Double click on above image to view full picture

Zoom Out
Zoom In
Melting Point Melting Point
-29.7 °C (-21.4 °F)
Boiling Point Boiling Point
174.1°C (345.3°F)
Flash Point Flash Point
114.8 °F (46 °C) (cc)
Refer to SDS for detailed product information.
HAZ00003 HAZ00006
Signal word
Hazard statements
Flammable liquid. (Flammable liquids, category 3)
Overexposure may cause dizziness, nausea, muscle weakness, narcosis and respiratory failure.
Aspiration hazard if swallowed - may be fatal if swallowed and enters airways. (Aspiration hazard, category 1)
Precautionary statements

Eye contact: Immediately flush with plenty of water. After initial flushing, remove any contact lenses and continue flushing for at least 15 minutes. Assure adequate flushing by separating the eyelids with fingers. (P338)
Skin contact: Wash thoroughly with soap and water. Get medical attention if irritation develops or persists. (P352)
Store in a tightly closed container. (P404)
Do not breathe vapor. (P260)
Do not get in eyes, on skin or clothing. (P262)
This product should only by used by persons trained in the safe handling of hazardous chemicals. (P202)
Wash thoroughly after handling. Do not take internally. Eye wash and safety equipment should be readily available. (P264)
Respiratory Protection: If workplace exposure limit(s) of product or any component is exceeded (see TLV/PEL), or a risk assessment shows air-purifying respirators are appropriate, use of a NIOSH/MSHA approved air supplied respirator is advised. Use a full-face respirator with multi-purpose combination (US) or type ABEK (EN14387) respirator cartridges in absence of proper environmental control. Always use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU). Engineering and/or administrative controls should be implemented to reduce exposure.
Protective gloves must be worn to prevent skin contact. (P280)

UN Number UN #
Shipping Class Shp Class
Packing Group Packing