Catalog NumberCat. #
Contact Technical Service
1000 µg/mL in Dilute Sodium Hydroxide, Stabilizer
Number of ComponentsComps
5 x 20 mL
The matrix used in this standard might interfere with some analytical methods.
Refrig (0-5 °C)
|Analyte||CAS Number||Element Abbreviation||Target Concentration|
Molecular FormulaMol. Formula
Molecular of WeightMol. Weight
Melting Point (°C)
Boiling Point (°C)
Flash Point (°C)
Refer to SDS for detailed product information.
Harmful if swallowed. (Acute toxicity, oral, category 4)\nIrritating to skin. (Skin corrosion/irritation, category 2)\nIrritating to eyes. (Eye damage/irritation, category 2B)
Eye contact: Immediately flush with plenty of water. After initial flushing, remove any contact lenses and continue flushing for at least 15 minutes. Assure adequate flushing by separating the eyelids with fingers. (P338)\nSkin contact: Immediately wash skin with soap and plenty of water. Remove contaminated clothing. Get medical attention if symptoms occur. Wash clothing before reuse. (P360)\nIngestion: Wash out mouth with water. Never give anything by mouth to an unconscious person. Call a physician or poison control center if adverse effects develop. (P330)\nStore in a tightly closed container. (P404)\nDo not get in eyes, on skin or clothing. (P262)\nThis product should only by used by persons trained in the safe handling of hazardous chemicals. (P202)\nWash thoroughly after handling. Do not take internally. Eye wash and safety equipment should be readily available. (P264)\nRespiratory Protection: If workplace exposure limit(s) of product or any component is exceeded (see TLV/PEL), or a risk assessment shows air-purifying respirators are appropriate, use of a NIOSH/MSHA approved air supplied respirator is advised. Use a full-face respirator with multi-purpose combination (US) or type ABEK (EN14387) respirator cartridges in absence of proper environmental control. Always use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU). Engineering and/or administrative controls should be implemented to reduce exposure.
Un NumberUN #
Shipping ClassShp Class